|
|
Model 3000 Intravenous Fluid Warmer
For prices and ordering
information please
Phone
250-642-7057 - Fax
250-642-7074
or
 EMAIL
Info@hypothermia-ca.com
|
IV WARMER is rugged and portable
with a soft case
that can go anywhere
|
Model 3000 Intravenous Fluid Warmer
(FDA K921395)
One
of the advantages of warmed IV Fluids at normal body temperature
is the improved absorption of
administered medications (+/- 10% per degree F compared to cold IV
fluids)
Cold IV fluids may induce hypothermia in compromised
patients and those that are predisposed to hypothermia, for
example:
- further cooling of hypothermic patients
- cooling of traumatized patients (slowed
metabolic heat production)
- cooling of geriatric patients
(poor
circulation, slowed metabolism) - diabetic patients
- cooling of pediatric patients (small body
mass)
- cooling of burn victims (replacing plasma
loss)
- Holds at a safe temperature indefinitely
with out overheating
|
Life-saving equipment
keeping hypothermia victims alive with core rewarming techniques,
supplying warm humidified air or oxygen and warm IV-fluids to minimize
core-temperature afterdrop.
|
IV WARMER
loses only one degree in ten minutes - at
below freezing in a 5 to 10 knot wind when disconnected from the power
source.
Basic Treatment for Hypothermia:
IV
fluids should be heated to approximately 104° - 108° F (40o– 42° C), but should be no colder than the patient’s core temperature.
(STATE OF ALASKA COLD INJURIES GUIDELINES Revised 1/2005)
|
Hypothermia Equipment for
the Treatment of Hypothermia victims in the field,
during transportation and in the emergency room.
Operates on 12 Volts from any vehicle or portable
battery - only 4 Ampere current drain
Runs on 115 Volts AC with optional transformer
Dispense IV fluids directly from bag
Temperature controlled, with
a additional over-temperature control thermostat
Fused for short-circuit protection
Case and insulation are fire
retardant
One year guarantee against electrical failure
|
Holds one or two - 1 Liter IV
fluid bags.
|
Optional Insulated IV Sleeve
Reduces Temperature Loss of IV
solution between
IV WARMER to Patient in Extreme Weather Conditions
Allows steady and sure flow rate of IV in extreme
temperature/wind chill conditions
Flexible insulated cloth construction with Velcro
fastening to IV Warmer
Covers entire length of IV tube
Clear vinyl window allows view of drip chamber
Insulated end flap covers patient needle entry
area
Sleeve does not restrict flow in any way
Velcro straps allow sleeve to be secured to
patient's arm
|
Shown with optional sleeve and
110 volt to 12 volt power supply
|
For prices and ordering
information please
Phone
250-642-7057 - Fax
250-642-7074
or
EMAIL
back to top
|
Alaskan Protocol